Model 23

This is for the stamp only – must purchase type separately

Model 23 Press Mounted Type Holder 

The Model 23 is used to stamp repetitive sequences on metal plates. Either by hand or by press, the Model 23 offers a quick alternative by stamping a uniformly spaced and aligned character sequence. Because the operator “sets” the type, virtually any sequence or code can be obtained.

A replaceable heat-treated steel anvil is used to support the base of the type characters. A type holding pin seats on a taper and prevents the notched type from falling out. During the marking operation, pressure bears on the replaceable anvil, rather then on the slot or pin.

The Model 23 is available in numerous sizes and capacities, which start at 4 pieces and then increase incrementally by 2 pieces up to 16 pieces, depending on character sizes. By choosing the proper capacity, the use of blank spacers to fill voids can be minimized. Thus, setups can be accomplished quicker and easier. We strive to maintain over 110 different sizes and capacity holders. Refer to our price list for different sizes and capacities.

The Model 23P is equipped with a 1″ diameter 1-1/4″ or 2″ long shank for use with most hand or power presses. For presses requiring a special round shank, consult the price list. For any other shank shape, request a factory quote. This machine is also equipped with an optional standard dovetail shank, which is recommended for use in Numberall’s hand or power presses. By using the shanks outlined in the price list, the Model 23P can easily be adapted to our various platforms or stamp holders.

Steel Type Fonts

Numberall’s steel type can be purchased in individual pieces but is also available in fonts, allowing you to have multiples pieces of each letter, number, symbols and blanks at your fingertips. Refer to the following chart for complete character break down of the 3A and 5A Fonts, showing which characters and how many of each character are included.